1. Verify that all the Powerline AV Ethernet Adapters to be configured are plugged in.

The default encryption key is HomePlugAV (default setting)

2. To use a private encryption key instead of the default key, follow these steps:

a. On the first Powerline AV Ethernet Adapter, press its security button for 2 seconds. The power LED will start blinking after you release the button. The adapter will produce a new, randomly generated network encryption key that each Powerline AV Ethernet Adapter will use. At this point, the other adapters in your network cannot communicate with each other.

b. WIthin 2 minutes of pushing the security button of the first adapter, push the security button the second adapter for 2 seconds. Both buttons must be pushed within 2 minutes. This securely configures your Powerline network with the same network encryption key. The adapters retain security settings even if they are unplugged.

c. If your network has more than 2 adapters, push the button on the additional adapter for 2 seconds, then push the button on any adapter in your existing network for 2 seconds.Both buttons must be pushed within 2 minutes.

Remark: An adapter can only generate a private key once. To replace a private key, first reset the unit back to its factory defaults by pressing the reset button for 10 seconds, then follow the procedure above.

3. To add more adapters into your network:

a. Push the security button on the new adapter for 2 seconds, then push the button on any adapter in your existing network for 2 seconds. Both buttons must be pushed within 2 minutes.

b. Repeat the previous step (3.a.) for any additional adapters you are adding.